Integrating NerveCenter with a Network
Management Platform
-
Integrating NerveCenter with HP OpenView IT/Operations - The OpenView Platform Adapter - How to Start and Stop the OpenView Platform Adapter -
The NerveCenter component that allows you to integrate NerveCenter with HP OpenView IT/Operations is known as the OpenView Platform Adapter. Following a typical installation of the NerveCenter OpenView Platform Adapter component, NerveCenter enabled the OpenView Platform Adapter to run automatically as a service of IT/Operations.
Therefore, whenever you start IT/Operations services by typing ovstart, the NerveCenter OpenView Platform Adapter will automatically start with any other IT/Operations services.
In the same way, typing ovstop stops all IT/Operations services, including the NerveCenter OpenView Platform Adapter.
If you want to start only the NerveCenter OpenView Platform Adapter, you can type at the command line:
ovstart ovpa
If you want to stop only the NerveCenter OpenView Platform Adapter, you can type at the command line:
ovstop ovpa
| Previous: How to Enable and Disable the Platform Adapter | Next: Using IT/Operations as a node source |
| Please send comments or corrections to Information Development | This file was last updated on 10 October 2000 |