Integrating NerveCenter with a Network Management Platform - Integrating NerveCenter with HP OpenView IT/Operations - The OpenView Platform Adapter - How to Enable and Disable the Platform Adapter -
Previous: The OpenView Platform Adapter     Next: How to Start and Stop the OpenView Platform Adapter

How to Enable and Disable the Platform Adapter

A typical NerveCenter installation automatically enables the NerveCenter OpenView Platform Adapter. However, there may be times you will need to disable the NerveCenter OpenView Platform Adapter. Once you disable it, you will need to enable it manually before NerveCenter will be able to integrate with IT/Operations again. You can enable or disable the NerveCenter OpenView Platform Adapter by following the procedures described in this section.

Enabling the NerveCenter OpenView Platform Adapter

If the NerveCenter OpenView Platform Adapter is disabled or was never enabled during NerveCenter installation, you can enable it at any time by adding the OpenView Platform Adapter local registration file (ovpa.lrf) to the list of services that are started by ovstart.

 
  To enable the NerveCenter OpenView Platform Adapter:

  1. From the command line of the machine hosting HP OpenView IT/Operations, run ovstop.

    The IT/Operations services stop running.

  2. Navigate to the following directory:
  3. Run the following command:
       ovaddobj ovpa.lrf
  4. Run ovstart.

    IT/Operations's services, including NerveCenter OpenView Platform Adapter, start running.

The NerveCenter OpenView Platform Adapter will now automatically run every time you start IT/Operations.

Disabling the NerveCenter OpenView Platform Adapter

If the NerveCenter OpenView Platform Adapter is enabled, you can disable it at any time by removing the OpenView Platform Adapter local registration file (ovpa.lrf) from the list of services that are started by ovstart.

 
  To disable the NerveCenter OpenView Platform Adapter:

  1. From the command line of the machine hosting HP OpenView IT/Operations, run ovstop.

    IT/Operations's services stop running.

  2. Navigate to the following directory:
  3. Run the following command:
       ovdelobj ovpa.lrf
  4. Run ovstart.

    IT/Operations's services, including NerveCenter OpenView Platform Adapter, start running.

The NerveCenter OpenView Platform Adapter will no longer automatically run every time you start IT/Operations.


Previous: The OpenView Platform Adapter Next: How to Start and Stop the OpenView Platform Adapter
Please send comments or corrections to Information Development
This file was last updated on 10 October 2000