Integrating NerveCenter with a Network Management Platform - Integrating NerveCenter with HP OpenView Network Node Manager - The OpenView Platform Adapter - How to Start and Stop the OpenView Platform Adapter -
Previous: How to Enable and Disable the Platform Adapter     Next: Using OpenView as a node source

How to Start and Stop the OpenView Platform Adapter

The NerveCenter component that allows you to integrate NerveCenter with HP OpenView Network Node Manager is known as the OpenView Platform Adapter. Following a typical installation of the NerveCenter OpenView Platform Adapter component, NerveCenter enabled the OpenView Platform Adapter to run automatically as a service of OpenView.

Therefore, whenever you start OpenView services by typing ovstart, the NerveCenter OpenView Platform Adapter will automatically start with any other OpenView services.

In the same way, typing ovstop stops all OpenView services, including the NerveCenter OpenView Platform Adapter.

If you want to start only the NerveCenter OpenView Platform Adapter, you can type at the command line:


   ovstart ovpa

If you want to stop only the NerveCenter OpenView Platform Adapter, you can type at the command line:


   ovstop ovpa


Previous: How to Enable and Disable the Platform Adapter Next: Using OpenView as a node source
Please send comments or corrections to Information Development
This file was last updated on 10 October 2000